top of page
Ocheret 1-501

Ocheret 1-501

VAT Included |

OCHERET 1-501 ankle boots are designed for use in extreme summer / demi-season operation. Reinforced sock and heel protect against cuts, scratches and bumps. A distinctive feature is the presence of a leather seal with a polyurethane coating along the entire foot just above the two-layer sole. All elements of the bottom of the shoe are fixed with a triple stitch to increase the strength of the stitching. Lacing is high-speed, traditionally there are additional lacing loops for tighter lacing. Suitable for military, volunteers and other law enforcement agencies.

Features (technical characteristics):

Model name: OCHERET


Article: SG 1-501

Season: summer and demi-season

Temperature mode: to -5C

Top material: original CORDURA®

Additional materials: sock, heel and area above the sole reinforced with genuine leather with polyurethane coating and thermoplastic insert

Lining: three-layer nonwoven mesh MESH ENERGY

Insole: molded, replaceable; enhances the cushioning properties of the sole; material - polyurethane

Sole: two-layer polyurethane with "anti-shock" properties, oil and gasoline resistant; at short contact maintains temperature to 120 ° C; created by the method of in-house casting;

Protector: self-cleaning; increased toughness on slippery / wet surfaces

Lacing: accessories are covered with anti-reflective paint; eyelets and hooks for high-speed lacing; additional hidden lacing loops

Laces: fully filled nylon; designed for long-term operation

Additionally: the presence of a loop on the beret of the beret (simplifies shoeing).

This model successfully combines the lightness required for shoes in the summer with high wear resistance of materials, which meets the conditions of active use. The sole, moderately flexible and tight even on slippery surfaces, will allow you to feel confident both off-road and in city conditions. Reinforcement of the area strictly above the sole and a reinforced sock with a heel allow you to not pay too much attention to small bumps, branches or stones.

A good solution for long transitions is a lacing system with hooks, which allows less time to spend on lacing after stops, and a system of hidden loops that adjust and hold the lacing in a convenient position for the owner, even when the laces are untied.

The beret valve is completely connected to the main part of the shoe, which prevents sand, small stones or other dirt from getting into the shoe through lacing.

The polyurethane sole is equipped with a softer and springy middle layer, which actually acts as an "anti-shock". The minimum thickness of the sole is 2.5-3 cm (sock), the maximum (heel) is 4 cm.

The main feature of insoles, which are also made of polyurethane, is their "molding", ie different thickness along the entire length, which allows you to unload the foot during long movements; the minimum thickness of the insole is maintained under the toes, the maximum - in the heel, which enhances the cushioning properties of the sole.

Out of Stock
bottom of page